Audi 80/90/Coupe

Since 1986-1991 of release

Repair and car operation



Audi 80/90/Coupe
+ 1.2. Car identification
+ 2. Engines, carburettors
3. Greasing system
+ 4. Cooling system
+ 5. Fuel system
+ 6. An exhaust system
+ 7. Ignition system
+ 8. Transmission
+ 9. Suspension brackets, wheels
- 10. Brake system
   10.1.2. Brake Pads forward brakes
   10.1.3. Brake Pads back brakes
   10.1.4. The general adjustment of back brakes (Girling)
   10.1.5. Replacement brake колодок (all-wheel drive models)
   10.1.6. The general adjustment of back brakes (Girling) (all-wheel drive models)
   10.1.7. Plugs of pedals of a brake and coupling
   10.1.8. Adjustment of a manual brake
   10.1.9. Removal of the lever of a manual brake
   + 10.2. Hydraulic components
   - 10.3. Antiblocking system of brakes
      10.3.2. The hydraulic pump
      10.3.3. The electronic block of management
      + 10.3.4. Elements ABS of a forward wheel
      + 10.3.5. Elements ABS of back brakes
      10.3.6. Broad-brush observations on repair
+ 11. A steering
+ 12. A body, salon
+ 13. A central air
+ 14. An electric equipment





10.3. Antiblocking system of brakes

10.3.1. Work with system of antiblocking of brakes
THE GENERAL DATA

The system of antiblocking of brakes (ABS) basically does not demand service.

The heat and electric categories can damage system ABS.

Disconnect a socket of connection from the management block before electric welding use at car repairs.

It is impossible to subject the management block to a heat, above 95оС, such as for example, in the furnace for drying of a body after colouring or a blowtorch even for short time, and also, it is impossible to subject the management block to temperature more low-85oS more, than within 2 hours.

Remove the block of management from the car if it is necessary.

At check ABS do not maintain the car at the connected instrumentations.

Check after repair of brake system

After repair or replacement

– Brake колодок;
– Brake disks;
– Hoses;
– The working cylinder;
– Elements of a manual brake;
– Pass on the car with a speed more than 6 km/h;
– The alarm bulb should not light up, if system ABS is perfectly in order.

After repair of elements ABS, such as

– The hydraulic pump;
– The management block;
– The gauge of speed;
– Connection wires;
– Brake hoses;
– Distributive valves;
– Check up ABS by means of a tester.