Audi 80/90/Coupe

Since 1986-1991 of release

Repair and car operation



Audi 80/90/Coupe
+ 1.2. Car identification
+ 2. Engines, carburettors
3. Greasing system
+ 4. Cooling system
+ 5. Fuel system
+ 6. An exhaust system
+ 7. Ignition system
+ 8. Transmission
+ 9. Suspension brackets, wheels
+ 10. Brake system
- 11. A steering
   11.2. A shaft and a casing of a steering column
   11.3. A power absorbing steering column
   11.4. A steering drive
   11.5. The pipeline of high pressure / the return pipeline
   11.6. Free wheeling adjustment рейки a steering
   11.7. A klinovoj belt
   + 11.8. System of hydrostrengthening of a steering
+ 12. A body, salon
+ 13. A central air
+ 14. An electric equipment





11.3. A power absorbing steering column

Removal

PERFORMANCE ORDER
1) disconnect a wire of the negative plug of the accumulator for switching-off of system of an air cushion of safety
2) establish forward wheels directly
3) remove a safety air cushion
4) remove a casing of the block of switches of a steering column (it is specified by arrows)
5) disconnect a socket of connection of an air cushion of the safety, located under a casing of the block of switches of a steering column. For this purpose, by means of a screw-driver, press a uvula (it is specified by an arrow) on the brink of a socket
6) remove a steering wheel
7) ослабьте a clip on the block of switches of a steering column also remove the block of switches
8) remove screws (are specified by arrows), fastening an instrument guard
9) disconnect a socket of connection and remove an instrument guard
10) disconnect a socket of the lock of ignition from the lock of a steering column
11) turn off four bolts of fastening of the knee buffer and remove a cap (it is specified by an arrow)
12) disconnect control sockets from the knee buffer and clean them aside
13) remove the knee buffer
14) disconnect the basis of a shaft of a steering column (it is specified by arrows) from a fixing arm
15) by means of a screw-driver in length about 15 mm, accurately remove a cover from a shaft of a steering column
16) turn off nuts (are specified by arrows), fastening a casing of a steering column / a fixing plate to a fixing arm
17) lower a steering column downwards and turn it so that it it was possible to remove from below panels of devices

Installation

PERFORMANCE ORDER
1) establish a steering column from below in an aperture of the panel of devices
2) establish a steering column / a fixing plate on a fixing arm. Insert bolts
3) insert a key into the ignition lock
4) unlock the lock of a steering column that it was possible to rotate a shaft of a steering column
5) press the basis of a steering column to a tube with flanges and to a fixing arm by means of flat-nose pliers. Connect them by means of bolts
6) tighten fastening nuts (are specified by arrows) steering column and arm
7) connect a socket of the lock of ignition to the lock of a steering column

The prevention

Do not try to straighten elements of a steering or to spend on them repair welding works.