Audi 80/90/Coupe

Since 1986-1991 of release

Repair and car operation



Audi 80/90/Coupe
+ 1.2. Car identification
+ 2. Engines, carburettors
3. Greasing system
+ 4. Cooling system
+ 5. Fuel system
+ 6. An exhaust system
+ 7. Ignition system
+ 8. Transmission
+ 9. Suspension brackets, wheels
+ 10. Brake system
- 11. A steering
   11.2. A shaft and a casing of a steering column
   11.3. A power absorbing steering column
   11.4. A steering drive
   11.5. The pipeline of high pressure / the return pipeline
   11.6. Free wheeling adjustment рейки a steering
   11.7. A klinovoj belt
   - 11.8. System of hydrostrengthening of a steering
      11.8.1. Technical characteristics
      11.8.2. Prorolling / filling of a hydraulic liquid
      11.8.3. Check on tightness (at the working engine)
      11.8.4. Steering transfer
      11.8.5. The pump of the hydraulic booster of a steering (Vickers)
+ 12. A body, salon
+ 13. A central air
+ 14. An electric equipment





11.8.2. Prorolling / filling of a hydraulic liquid
THE GENERAL DATA

The prevention

Do not use an old hydraulic liquid.


Arrangement of marks in a tank with a liquid for the wheel hydraulic booster


PERFORMANCE ORDER
1) add a hydraulic liquid to a mark the MOVE
2) lift the car by means of a jack and at the switched off engine sharply turn a steering wheel from one extreme position to another some times for prorolling of system of hydrostrengthening
3) add a hydraulic liquid to a mark the MOVE
4) start the engine and allow to it to work in a single mode about 2 minutes, wheels thus should stand directly
5) observe a hydraulic liquid in a tank
6) after in a hydraulic liquid will cease to appear vials, muffle the engine and check up liquid level; if it is necessary, add a hydraulic liquid to a mark the MOVE

The system of hydrostrengthening of a steering is pumped over automatically after a while at the working engine.

System of cooling of a hydraulic liquid

1. An inlet hose
2. An arm
3. 10 Н.м., always replace
4. An ohladitelnaja tube
5. A collar
6. A tank, check up liquid level in a tank after the engine will work within 2 minutes, wheels thus should stand directly
Muffle the engine, check up level of a liquid and add to a mark the MOVE if it is necessary
7. 10 Н.м.
Always replace
8. A collar
9. A collar
10. Sealing rings
Always replace
11. A bolt "банджо"
The inhaling moment: 50 Н.м.