Audi 80/90/Coupe

Since 1986-1991 of release

Repair and car operation



Audi 80/90/Coupe
+ 1.2. Car identification
+ 2. Engines, carburettors
3. Greasing system
+ 4. Cooling system
+ 5. Fuel system
+ 6. An exhaust system
+ 7. Ignition system
+ 8. Transmission
+ 9. Suspension brackets, wheels
+ 10. Brake system
- 11. A steering
   11.2. A shaft and a casing of a steering column
   11.3. A power absorbing steering column
   11.4. A steering drive
   11.5. The pipeline of high pressure / the return pipeline
   11.6. Free wheeling adjustment рейки a steering
   11.7. A klinovoj belt
   - 11.8. System of hydrostrengthening of a steering
      11.8.1. Technical characteristics
      11.8.2. Prorolling / filling of a hydraulic liquid
      11.8.3. Check on tightness (at the working engine)
      11.8.4. Steering transfer
      11.8.5. The pump of the hydraulic booster of a steering (Vickers)
+ 12. A body, salon
+ 13. A central air
+ 14. An electric equipment





11.8.5. The pump of the hydraulic booster of a steering (Vickers)
THE GENERAL DATA

The pump of the hydraulic booster of a steering (Vickers)

1. 45 Н.м.
2. A sealing ring
Always replace
3. A high pressure tube
The moment of an inhaling of fastening: 45 Н.м.
4. A sealing ring
Always replace
5. 20 Н.м.
6. An arm
7. 20 Н.м.
8. 50 Н.м.
9. A sealing ring
Always replace
10. A soaking up hose
11. A sealing ring

12. The lopastnoj pump
Exist лопастные pumps раличных kinds
Before installation, fill soaking up part with a hydraulic liquid and повращайте the pump that the liquid began to leave the target channel
13. The tension device
14. The Bolt / a nut of the tension device
15. 20 Н.м.
16. A pulley клинового a belt
Establish a mark "4Z" forward
17. 25 Н.м.
18. A klinovyj belt, 12.5x992 mm

The prevention

The hydrostrengthening system is filled by a hydraulic liquid, detail G 002 000.


Tension клинового a belt



PERFORMANCE ORDER
1) ослабьте a nut 1
2) ослабьте a bolt 2
3) turn a nut 3 on the tension device for a belt tension
4) a belt will pull correctly if it caves in under the pressure of a finger approximately on 10 mm in the middle between two pulleys
5) tighten a bolt 2
6) tighten a nut 1








бизнес иммиграция в сша