Audi 80/90/Coupe

Since 1986-1991 of release

Repair and car operation



Audi 80/90/Coupe
+ 1.2. Car identification
+ 2. Engines, carburettors
3. Greasing system
+ 4. Cooling system
+ 5. Fuel system
+ 6. An exhaust system
+ 7. Ignition system
+ 8. Transmission
+ 9. Suspension brackets, wheels
+ 10. Brake system
+ 11. A steering
+ 12. A body, salon
- 13. A central air
   13.2. Pressure switches
   13.3. The valve of descent of water
   13.4. A klinoobraznyj belt of the compressor of the conditioner
   13.5. Check of vacuum system
   13.6. Places of connections of lines of a coolant, a throttle
   13.7. The conditioner compressor
   13.8. Муфта the conditioner compressor
+ 14. An electric equipment





13.4. A klinoobraznyj belt of the compressor of the conditioner
THE GENERAL DATA

Klinoobraznyj belt of the compressor of the conditioner (the 4-cylinder engine)

The belt tension is regulated by addition or removal of linings between pulley halves коленвала (it is specified by an arrow).

Klinoobraznyj belt will pull correctly if it can be delayed approximately on 5 mm.

Hold not used linings in a forward part of a pulley коленвала, between a pulley and fixing bolts.


The prevention

When you regulate a belt tension, tighten pulley bolts коленвала by turns, turning thus коленвал.


The inhaling moment: 22 Н.м.

Klinoobraznyj belt of the compressor of the conditioner (the 5-cylinder engine)

Klinoobraznyj belt will pull correctly if it can be delayed approximately on 5 mm.

ослабьте bolts In;
– Pull a belt, having twisted a bolt And;
– Tighten bolts In: 22 Н.м.;
– Unscrew a bolt And until between it and the engine case the backlash at least in 5 mm is not formed;
– Fix an adjusting bolt And in such position by means of a counternut


The prevention

The bolt And is used only for adjustment. Do not leave this bolt pressed to the engine case.