Audi 80/90/Coupe

Since 1986-1991 of release

Repair and car operation



Audi 80/90/Coupe
+ 1.2. Car identification
+ 2. Engines, carburettors
3. Greasing system
+ 4. Cooling system
+ 5. Fuel system
+ 6. An exhaust system
+ 7. Ignition system
+ 8. Transmission
+ 9. Suspension brackets, wheels
+ 10. Brake system
+ 11. A steering
+ 12. A body, salon
+ 13. A central air
- 14. An electric equipment
   + 14.1.2. A thermoswitch, an electronic thermoswitch
   - 14.2. Electroconducting
      14.2.2. Updating rubber изоляционной plugs of the contact plug
      14.2.3. Holders of additional safety locks
      14.2.4. The locations and identification of safety locks
      14.2.5. Identification of contacts on a payment of safety locks and relay blocks
      14.2.6. An additional payment of blocks of the relay
      14.2.7. The locations of tips of a plait of wires in contact nests
      14.2.8. Points of grounding and welded connections of wires
      14.2.9. The locations of blocks of management
      14.2.10. An arrangement of devices in engine branch
   + 14.3. Electroschemes





14.2.2. Updating rubber изоляционной plugs of the contact plug
THE GENERAL DATA

Rubber изоляционная the plug (it is specified by an arrow) is established in some contact plugs of tips at factory the manufacturer. When you carry electroconducting out repairs, rubber изоляционную the plug is necessary for turning before again inserting into the tip case.

PERFORMANCE ORDER
1) get and cut off the old contact plug 1
2) remove from a wire rubber изоляционную the plug and turn it (on 180 )
3) examine and replace the plug if it is damaged
The prevention

In case of replacement the new plug should be the same colour, as well as old, it will allow to provide necessary tightness between a wire, the plug and the tip case.


4) put on the plug a wire so that the corbel (it is specified by an arrow) was from outside the contact plug 1
5) properly press the new plug 1 to a wire