Audi 80/90/Coupe

Since 1986-1991 of release

Repair and car operation



Audi 80/90/Coupe
+ 1.2. Car identification
+ 2. Engines, carburettors
3. Greasing system
+ 4. Cooling system
+ 5. Fuel system
+ 6. An exhaust system
+ 7. Ignition system
+ 8. Transmission
- 9. Suspension brackets, wheels
   9.1.1. Elimination of a resonance / of vibration of a cross-beam (4-cylinder models)
   9.1.2. Change of a design of a forward suspension bracket
   9.1.3. Полуось
   9.1.4. A suspension bracket rack
   9.1.5. SHRUS
   9.1.6. A suspension bracket rack (all-wheel drive models)
   9.1.7. SHRUS (all-wheel drive models)
   + 9.2. A back suspension bracket
   + 9.3. Wheels and tyres
+ 10. Brake system
+ 11. A steering
+ 12. A body, salon
+ 13. A central air
+ 14. An electric equipment





9. Suspension brackets, wheels

9.1. A forward suspension bracket
THE GENERAL DATA

Forward suspension bracket – draughts and semiaxes

1. The rubber plug
It is established only on models with 4-cylinder engines
2. The stabilizer of cross-section stability
3. The plug of the stabilizer of cross-section stability
4. 35 Н.м.
5. An arm
6. A clip
It is necessary to establish the plug of the stabilizer of cross-section stability correctly
7. 40 Н m.
8. 40 Н.м.
After a twisting till the demanded moment of an inhaling turn in addition on a turn quarter (90 )
9. A bolt and a washer
Always replace
10. The plug of the lever of a forward suspension bracket
11. The rubber plug of the stabilizer of cross-section stability
12. 65 Н.м.
13. The spherical hinge
Note installation position at removal from a rack of the bearing of a nave of a wheel
Adjust disorder of forward wheels after installation
14. The lever of a forward suspension bracket
Differ on a design on the left and right party
15. The plug
Insert into the rubber plug
16. Connecting draught
Establish so that sides were at right angle to a direction of movement of the car
17. 35. Н.м.
Turn in addition on a turn quarter
Always replace
18. A washer
Always replace
19. The plug of the stabilizer of cross-section stability
20. A bolt
The head should look forward
21. 65 Н.м.
22. The plug
23. 20 Н.м.
24. The back plug of a cross-beam of a forward suspension bracket
25. A cross-beam of a forward suspension bracket
Various updatings for models with 4 and 5-cylinder engines
Tighten fastenings in a following order:
1. The back left
2. The back right
3. The forward left
4. The forward right

26. The forward plug of a cross-beam предней suspension brackets

The prevention

Do not try to spend welding works or to level elements of a forward suspension bracket which are responsible for fastening and installation of wheels.

At repair always replace always replace all bolts, washers and самоконтрящиеся nuts, fastening suspension bracket elements, such as a cross-beam of a forward suspension bracket, suspension bracket levers, the stabilizer of cross-section stability, spherical hinges etc.