Audi 80/90/Coupe

Since 1986-1991 of release

Repair and car operation



Audi 80/90/Coupe
+ 1.2. Car identification
+ 2. Engines, carburettors
3. Greasing system
+ 4. Cooling system
+ 5. Fuel system
+ 6. An exhaust system
+ 7. Ignition system
+ 8. Transmission
- 9. Suspension brackets, wheels
   9.1.1. Elimination of a resonance / of vibration of a cross-beam (4-cylinder models)
   9.1.2. Change of a design of a forward suspension bracket
   9.1.3. Полуось
   9.1.4. A suspension bracket rack
   9.1.5. SHRUS
   9.1.6. A suspension bracket rack (all-wheel drive models)
   9.1.7. SHRUS (all-wheel drive models)
   + 9.2. A back suspension bracket
   + 9.3. Wheels and tyres
+ 10. Brake system
+ 11. A steering
+ 12. A body, salon
+ 13. A central air
+ 14. An electric equipment





9.1.7. SHRUS (all-wheel drive models)
THE GENERAL DATA

The prevention

Semiaxis greasing on cars with a full drive (Quattro): grease an internal and external SHRUS in 90 grammes of greasing G6 everyone.


Полуось – for all-wheel drive models

1. A convex washer – 2 types:
1. With internal шлицами
2. With external шлицами

At replacement establish a washer of the same type
2. A lock ring
Establish in a ring flute on a semiaxis (it is not visible at the established hinge)
3. An external SHRUS
Remove only entirely
Installation: establish the hinge on полуось with the help киянки so that it was possible to establish a lock ring
4. A persistent washer
5. A convex washer
6. A shlangovyj clip
7. A cover
Check up on presence of cracks and wear tracks
8. A clip
9. Полуось
Various length on the left and right party
10. A cover with a cover
11. An internal SHRUS
External diameter for model
Quattro: 100 mm
12. An epiploon
Replacement: remove a protective film and paste on the hinge
13. A lock ring

Convex and persistent washers, installation position
1. A lock ring

2. A persistent washer

3. A convex washer

Removal and installation the SHRUS

PERFORMANCE ORDER
1) tighten a clip
2) at installation the cover can be pressed that further at car operation can lead to occurrence of folds;
After installation for a second slightly open the end of a cover with smaller diameter to level pressure inside and outside, such ventilation of a cover will prevent occurrence of folds

3) clamp полуось in a vice

4) remove a cover
5) twist the special tool while the SHRUS will not be removed from a semiaxis
6) remove a lock ring internal the SHRUS
7) remove an internal SHRUS
8) establish the hinge against the stop
9) establish a lock ring
10) establish a convex washer
11) note position








бизнес иммиграция в сша