Audi 80/90/Coupe

Since 1986-1991 of release

Repair and car operation



Audi 80/90/Coupe
+ 1.2. Car identification
+ 2. Engines, carburettors
3. Greasing system
+ 4. Cooling system
+ 5. Fuel system
+ 6. An exhaust system
+ 7. Ignition system
+ 8. Transmission
- 9. Suspension brackets, wheels
   9.1.1. Elimination of a resonance / of vibration of a cross-beam (4-cylinder models)
   9.1.2. Change of a design of a forward suspension bracket
   9.1.3. Полуось
   9.1.4. A suspension bracket rack
   9.1.5. SHRUS
   9.1.6. A suspension bracket rack (all-wheel drive models)
   9.1.7. SHRUS (all-wheel drive models)
   + 9.2. A back suspension bracket
   - 9.3. Wheels and tyres
      9.3.2. Disorder / a convergence of wheels
+ 10. Brake system
+ 11. A steering
+ 12. A body, salon
+ 13. A central air
+ 14. An electric equipment





9.3. Wheels and tyres

9.3.1. Technical characteristics
THE GENERAL DATA

Model
The size of the tyre
Wheels
Depth of a disk / diameter of a ring of bolts of fastening of a wheel
Ауди-80
175/70 HR 14
5-1/2 J х 14*
45/108
Ауди-90
195/60 HR 14
6 J х 14
45/108
Spare wheel
115/70 R 15
4 J х 14
56/108
125/90 R 15
4 J х 14
45/108

* Wheels with steel disks

Wheel in gathering

1. The tyre
On forward wheels it is recommended to establish tyres with deeper protector
Establish tyres only identical type and with identical drawing of a protector
2. A fixing spring for balancing грузика
3. Balancing грузик
On cast disks грузики fasten by means of glue
4. A wheel cap
5. A bolt of fastening of a wheel
The inhaling moment: 110 H.м.
М14 х 1.5 x 27.5 mm
6. A wheel disk
5-1/2J X 14, depth of a rim of 45 mm (for wheels with steel disks)
6 J X 14, depth of a rim of 45 mm (a disk from easy alloys)
7. The chamber valve
Establish the new valve at wheel replacement

Wheel with легкосплавным a disk

1. The tyre
With a view of safety of the tyre should be replaced only with steams
On forward wheels it is recommended to establish tyres with deeper protector
Establish tyres only identical type and with identical drawing of a protector
2. Balancing грузики
For installation: clear a rim of a wheel of oil and greasing, remove a protective film with грузика and paste it on a disk
3. A legkosplavnyj disk – trellised design 6J х 14
4. A nave cap
5. A cap
The blocking cylinder is established
6. The blocking cylinder
It is established on a wheel bolt
7. A bolt of fastening of a wheel
The inhaling moment: 110 H.м.
М14 х 1.5 x 27.5 mm
8. The chamber valve
Establish the new valve at wheel replacement